作者投稿和查稿 主编审稿 专家审稿 编委审稿 远程编辑

计算机工程 ›› 2010, Vol. 36 ›› Issue (14): 224-226. doi: 10.3969/j.issn.1000-3428.2010.14.081

• 工程应用技术与实现 • 上一篇    下一篇

多处理器阵列的JTAG调试系统设计

黄光红1,洪 一1,2,耿 锐1,陆俊峰1   

  1. (1. 华东电子工程研究所,合肥 230031;2. 中国科学技术大学信息科学技术学院,合肥 230027)
  • 出版日期:2010-07-20 发布日期:2010-07-20
  • 作者简介:黄光红(1982-),男,助理工程师,主研方向:嵌入式软件开发;洪 一,研究员、博士生导师;耿 锐、陆俊峰,工程师

Design of JTAG Debug System for Multiprocessor Array

HUANG Guang-hong1, HONG Yi1,2, GENG Rui1, LU Jun-feng1   

  1. (1. East China Research Institute of Electronic Engineering, Hefei 230031; 2. School of Information Science and Technology, University of Science and Technology of China, Hefei 230027)
  • Online:2010-07-20 Published:2010-07-20

摘要: 针对多处理器系统开发难度大、效率低等问题,提出基于联合测试行动组的多处理器系统远程调试方案。该方案可以实现多处理器的同步和异步调试,提供多种调试方式。在Linux系统下实现该调试系统,仿真测试和实际应用证明该方案是有效的,能较大地提高系统的开发效率。

关键词: 联合测试行动组, 多处理器, 远程调试, 同步调试

Abstract: Aiming at the problems that the development of multiprocessor system is difficult and its efficiency is low, this paper proposes a remote debug scheme based on Joint Test Action Group(JTAG) for multiprocessor system. It realizes synchronous and asynchronous debug for multiprocessor, and offers abundant debug means. The multiprocessor debug system is implemented under Linux. Simulation test and practical application demonstrate that the scheme is efficient, and it can improve the efficiency of system development.

Key words: Joint Test Action Group(JTAG), multiprocessor, remote debug, synchronous debug

中图分类号: