作者投稿和查稿 主编审稿 专家审稿 编委审稿 远程编辑

计算机工程 ›› 2010, Vol. 36 ›› Issue (15): 259-261. doi: 10.3969/j.issn.1000-3428.2010.15.092

• 开发研究与设计技术 • 上一篇    下一篇

基于XCF32P的多FPGA配置方案

张承畅1,严单贵2,杨力生1,齐怀龙1,杨 宏1   

  1. (1. 重庆大学通信与测控中心,重庆 400044;2. 重庆邮电大学数理学院,重庆 400086)
  • 出版日期:2010-08-05 发布日期:2010-08-25
  • 作者简介:张承畅(1975-),男,博士研究生,主研方向:软件无线电;严单贵,讲师;杨力生,教授;齐怀龙,硕士研究生;杨 宏,本科生
  • 基金资助:

    重庆市科技创新基金资助项目(2008BC2001);重庆邮电大学青年教师科技基金资助项目(A2007-30)

Multi-FPGA Configuration Scheme Based on XCF32P

ZHANG Cheng-chang1, YAN Dan-gui2, YANG Li-sheng1, QI Huai-long1, YANG Hong1   

  1. (1. Center of Communication and Tracking Telemetering Command, Chongqing University, Chongqing 400044; 2. College of Mathematics and Physics, Chongqing University of Post and Telecom, Chongqing 400086 )
  • Online:2010-08-05 Published:2010-08-25

摘要:

分析Xilinx Platform Flash PROM XCF32P的结构特点,提出基于XCF32P的多版本设计功能的多FPGA配置方案。采用从并配置模式,由XCF32P和1片CPLD XC9572来配置4片Virtex XCV200 FPGA。通过单一供应商解决方案,使系统的软、硬件设计得到简化,获得较高的配置速率。

关键词: 设计版本, 多FPGA, 配置

Abstract:

This paper analyses the structural characteristics of Xilinx Platform Flash PROM XCF32P, gives a configuration scheme for multi-FPGA system based on the design revisions of XCF32P. The scheme adopts slave SelectMAP model, uses XCF32P and a CPLD XC9572 to configure four Virtex XCV200 FPGAs, due to adopt a single vendor solution program, the system software and hardware design to be simplified, and it can receive a higher configuration rate.

Key words: design revision, multi-FPGA, configuration

中图分类号: