作者投稿和查稿 主编审稿 专家审稿 编委审稿 远程编辑

计算机工程 ›› 2018, Vol. 44 ›› Issue (6): 283-287. doi: 10.19678/j.issn.1000-3428.0047075

• 开发研究与工程应用 • 上一篇    下一篇

基于时隙分组的超高频RFID防碰撞算法

何伟健,陆江城,周灿煜,梁泳新,杨健   

  1. 广东工业大学 自动化学院,广州 510006
  • 收稿日期:2017-05-05 出版日期:2018-06-15 发布日期:2018-06-15
  • 作者简介:何伟健(1993—),男,硕士研究生,主研方向为嵌入式系统;陆江城,硕士研究生;周灿煜、梁泳新,学士;杨健(通信作者),讲师、博士。
  • 基金资助:
    广东省大学生创新创业训练计划项目“开放式超高频RFID读写器的设计”(201511845079)。

Anti-collision Algorithm of Ultra High Frequency RFID Based on Time Slot Grouping

HE Weijian,LU Jiangcheng,ZHOU Canyu,LIANG Yongxin,YANG Jian   

  1. School of Automation,Guangdong University of Technology,Guangzhou 510006,China
  • Received:2017-05-05 Online:2018-06-15 Published:2018-06-15

摘要: 传统动态帧时隙ALOHA算法容易造成较多的时隙浪费,且Q值调整速度缓慢,导致系统的吞吐率偏低。针对该问题,在分析传统Q算法的基础上,提出一种改进的防碰撞算法。利用时隙分组思想将Q算法中各轮盘存的时隙分为若干组,在每组时隙盘存结束后都根据估计的标签数量动态调整Q值。仿真和硬件平台实验结果表明,该算法的平均吞吐率比传统Q算法高7%左右,比MQ算法高3%左右。

关键词: 无线射频识别, 防碰撞算法, 动态帧时隙ALOHA算法, 时隙分组, Q算法

Abstract: The traditional Dynamic Framed Slot ALOHA(DFSA) algorithm easily brings the waste of time slot.What is more,the Q value is adjusted slowly.Therefore the throughput of Radio Frequency Identification(RFID) system is lower.Aiming at this problem,based on the analysis of the traditional Q algorithm,this paper proposes an improved anti-collision algorithm which is on the basis of time slot grouping,so as to eliminate above defect.In this algorithm,time slot can be divided into several groups based on the traditional Q algorithm.At the end of each inventory,it dynamically adjusts the Q value according to the estimated number of labels.The simulation results and the experimental results in hardware platform indicate that,the average throughput rate of this algorithm is about seven percent higher than traditional Q algorithm and is about three percent higher than MQ algorithm.

Key words: Radio Frequency Identification(RFID), anti-collision algorithm, Dynamic Framed Slotted ALOHA(DFSA) algorithm, time slot grouping, Q algorithm

中图分类号: